این ویدیو نحوه پیکربندی دو XBEE سری 1 را با استفاده از برد Arduino UNO شرح میدهد . روشهای برقراری ارتباط دو طرفه نیز در حالت بیسیم آزمایش میشوند.
![](https://i.ytimg.com/vi/S0WTsiocpIs/hqdefault.jpg)
بررسی اجمالی
محافظ Xbee به برد آردوینو اجازه می دهد تا با استفاده از Zigbee به صورت بی سیم ارتباط برقرار کند. این بر اساس ماژول Xbee از MaxStream است . این ماژول می تواند تا 100 فوت در داخل خانه یا 300 فوت در خارج از منزل (با خط دید) ارتباط برقرار کند. می توان از آن به عنوان جایگزین سریال/USB استفاده کرد یا می توانید آن را در حالت فرمان قرار دهید و آن را برای انواع گزینه های پخش و شبکه شبکه پیکربندی کنید. سپرها هر یک از پینهای Xbee را به یک پد لحیم کاری سوراخ میشکنند. همچنین هدرهای پین ماده را برای استفاده از پین های دیجیتال 2 تا 7 و ورودی های آنالوگ که توسط شیلد پوشانده شده اند ارائه می دهد (پین های دیجیتال 8 تا 13 توسط شیلد مسدود نمی شوند، بنابراین می توانید از هدرها روی خود برد استفاده کنید).
سپر Xbee با همکاری Libelium ایجاد شد، که آن را برای استفاده در موت های SquidBee خود (که برای ایجاد شبکه های حسگر استفاده می شود) توسعه داد.
برای جزئیات بیشتر: ARDUINO با XBEE- WIRELESS SETUP DEMO
در ادامه، متن انگلیسی این مطلب را میتوانید مشاهده نمایید:
This video describes how to configure two Series 1 XBEEs using Arduino UNO board.The ways of making 2 way communication is also tested on Wireless mode.
![](https://i.ytimg.com/vi/S0WTsiocpIs/hqdefault.jpg)
Overview
The Xbee shield allows an Arduino board to communicate wirelessly using Zigbee. It is based on the Xbee module from MaxStream. The module can communicate up to 100 feet indoors or 300 feet outdoors (with line-of-sight). It can be used as a serial/usb replacement or you can put it into a command mode and configure it for a variety of broadcast and mesh networking options. The shields breaks out each of the Xbee’s pins to a through-hole solder pad. It also provides female pin headers for use of digital pins 2 to 7 and the analog inputs, which are covered by the shield (digital pins 8 to 13 are not obstructed by the shield, so you can use the headers on the board itself).
The Xbee shield was created in collaboration with Libelium, who developed it for use in their SquidBee motes (used for creating sensor networks).
For more detail: ARDUINO with XBEE- WIRELESS SETUP DEMO